Welcome, Guest. Please login or register.

Author Topic: 3d Printing & Gaming  (Read 280 times)

Stewart 46A

  • Supporter 2020
  • Hog the Limelight
  • *
  • Posts: 1374
    • View Profile
Re: 3d Printing & Gaming
« Reply #15 on: March 22, 2020, 07:35:39 AM »
Antioch, great looking buildings, well done.

Stewart

Smiley Miley 66

  • Supporter 2020
  • Hog the Limelight
  • *
  • Posts: 863
    • View Profile
Re: 3d Printing & Gaming
« Reply #16 on: March 22, 2020, 07:57:31 AM »
Very nice buildings.
Miles

Antioch

  • Supporter 2020
  • Domestic Pig
  • *
  • Posts: 97
    • View Profile
Re: 3d Printing & Gaming
« Reply #17 on: March 23, 2020, 06:29:36 PM »
Just wanted to add a picture of what happens when things go wrong...avoiding any conception things work perfect all the time.

Bob


martin goddard

  • RFCM Admin Supporter
  • Hog the Limelight
  • *
  • Posts: 3742
    • View Profile
Re: 3d Printing & Gaming
« Reply #18 on: March 23, 2020, 06:41:24 PM »
Downed telegraph wires in the Lebanon I think?  Very authentic :)

Colonel Kilgore

  • RFCM Admin Supporter
  • Hog the Limelight
  • *
  • Posts: 3943
    • View Profile
Re: 3d Printing & Gaming
« Reply #19 on: March 23, 2020, 08:58:28 PM »
That is impressive, Bob - did you have an earthquake mid-print?

Simon

Antioch

  • Supporter 2020
  • Domestic Pig
  • *
  • Posts: 97
    • View Profile
Re: 3d Printing & Gaming
« Reply #20 on: March 23, 2020, 09:07:55 PM »
Well it sure looks like that but in reality what  happened here is the roof section only adheres to the build plate by a very narrow bit n each if the 4 sides... as more material gets applied...the piece comes loose & plastic is applied where the printer thinks it should be...and the more it moves (typically when you arenít around) the more of a mess it creates.

One of many problems that can happen...

Leman

  • Supporter 2020
  • Hog the Limelight
  • *
  • Posts: 1738
  • If it's too hard, I can't do it.
    • View Profile
Re: 3d Printing & Gaming
« Reply #21 on: March 24, 2020, 11:06:10 AM »
Like most things, just because it exists doesnít mean everybody can do it.

Antioch

  • Supporter 2020
  • Domestic Pig
  • *
  • Posts: 97
    • View Profile
Re: 3d Printing & Gaming
« Reply #22 on: March 26, 2020, 05:09:36 PM »
One if the Dutch/low land bridges I have been trying for, in 15 mm.... very fidley parts...may have to glue them. And of course i managed to pick a size just smaller then the 30mm bases. :o


Colonel Kilgore

  • RFCM Admin Supporter
  • Hog the Limelight
  • *
  • Posts: 3943
    • View Profile
Re: 3d Printing & Gaming
« Reply #23 on: March 26, 2020, 08:16:04 PM »
That's a nice model, Bob - the bricks will look great when painted too.

Simon